Step 1:

Using a 7/16 wrench, attach Base Bracket to your Kwick Strike Diamondback using the four 1-inch bolts provided.

Step 2:

Locate your seat base bracket (pictured below). This will be the main support in mounting the Kwick Strike Diamondback in your vehicle.

Step 3:

Place seat base bracket between your vehicle’s seat rail and console. 

If your vehicle does not have a console, simply place the seat base bracket next to your vehicle’s seat rail on the side where a console would be.

Step 4:

Place the clamp on the opposite side of seat rail so that the bolts loosely thread into the seat base bracket, but wait to tighten the clamp bolts.

Use a 7/16 wrench to tighten the seat base bracket bolt so that the seat base bracket does not move.

Tighten the clamp bolts using a 7/16 wrench so that the seat rail is tightly “clamped” between the seat base brackets.

Step 5:

Once the seat base bracket is secured around the vehicle’s seat rail, connect the ball mount to the seat base bracket. The ball mount may be moved around to desired fit and placement, then tighten the connecting bolt.

Step 6:

Attach the 3M Dual Lock provided as needed to secure the Kwick Strike and prevent movement while driving.

Step 7:

Attach the Kwick Strike to your vehicle mount using the ball mount. (TIP: Tighten the bolt enough that it stays attached, but leave it loose enough that you can still move to desired fit.)

Once in the desired location, tighten all bolts and adhere the Kwick Strike to the console using the 3M dual lock provided. (TIP: Use the alcohol pad to prep the surface for best results).

Once secured, your Kwick Strike is armed and ready to use!

For more information on how to properly use and care for your Kwick Strike, visit